| Features | Benefits |
|
914mm (36”) cylinder & bottom blade capacity. | Can accommodate all makes & sizes of cylinders up to 36" in and out of situ including pedestrian mowers. |
| Manual full relief cylinder grinding. | The cylinder can be returned to the original manufactures specification. Relief ground units maintain their sharpness a lot longer than spin ground units. |
| Grinds both top & front faces of the bottom blade | Bottom blade returned to original manufacturers specification. |
| Takes data measurements from cylinder shaft and rear roller. | Eliminates cylinder coning especially important on cutting units with fixed cylinders and rear rollers. |
| Cast bed construction | Reduces vibration and increases accuracy |
| Liquid coolant on all operations | Reduces air borne dust therefore no need for extractor fans. Stops heat build up and distortion. |
| 240 volt power supply | Can be readily plugged into normal 13-amp power supply. |
| Flexi drive to cutting cylinder. | Less vibration and allows for any misalignment in setting up. |
| Bearing pack |
Contains 6 pairs of bearings and holders for out of situ cylinder
grinding |
| Universal bracket pack | Allows all types of cutting unit to be mounted without the need to dismantle. |
| Hands free indexing attachment. | Allows the cutting cylinder to be accurately turned to each blade for relief grinding without the operators hands coming into contact with the cylinder. |
| Twin halogen work lights | Gives the operator the best possible view of the work area. |
| 360 degree 200kg hoist | The operator can easily load and unload the heaviest cutting units into the machine safely and with utmost ease. The hoist can also be used for other lifting work apart from when using the grinder with the strategic placement of workbenches. |
| 3” wheel head attachment | Allows ‘In-situ’ grinding of small multi blades cylinders. |
| Rotary blade attachment | Enables easy, accurate grinding of rotary blades. |
| Only one machine required for relief grinding cylinders and grinding both surfaces of bottom blades. | Only one machine required for all your grinding needs. Saves on workshop floor space and the need to transfer cylinders from one machine to another for relief and spin grinding. |
| One grinding wheel for all operations | Saves time by not having the need to change grinding wheels for relief and spin modes. |
| 2 emergency stop buttons. | One on the control panel and one at knee height at the opposite end to disable the machine should the need occur. |
| Full installation & training. | Ensures operators are fully conversant with all grinding aspects connected with the machine and will be provided with a certificate of competence. |
